Transcript
00:11
[Music]
00:14
the ballistically brilliant chronograph
00:16
firm Air Force one the fully portable
00:19
rechargeable battery powered chronograph
00:21
for indoor and outdoor use no auxiliary
00:24
light sauce required measures pellet
00:27
velocity in four pounds loss rate of
00:29
fire also record temperature humidity at
00:33
the time of the shot charging and data
00:35
cables are included comes with a backlit
00:38
display unscrews cut for tripod mounting
00:42
the use of functions are the mode
00:44
buttons to change between different
00:46
operating modes and programming the
00:49
backlight button for display
00:51
illumination and mode settings the data
00:55
outputs for the micro USB to your laptop
00:57
or PC the power on and off button on
01:02
auto shut off the power charging point
01:06
with the supplied lead the port with the
01:11
sensors make sure you aim straight down
01:13
the center the screw fixing points for a
01:17
camera stand
01:21
the colonel must be fully charged before
01:23
use and set your charging cable into the
01:26
port on the rear and then connected to
01:28
your laptop or charging device the red
01:31
light will show that it still requires
01:33
charging and then the green light will
01:35
say it’s all ready to use
01:38
turn on the power and the clock will be
01:41
displayed this will need to be set up
01:43
each Sami users next if you press the
01:46
backlight button and hold it then press
01:49
the mode button for one to two seconds
01:51
and release then it will be able to set
01:54
the clock time press the mode button
01:56
continuously until you get the correct
01:58
minutes once you’ve got the desired
02:02
minutes release press the backlight
02:06
button again which will bring in these
02:09
hours press the hours button until you
02:12
have the set hours displayed and press
02:14
the backlight button again to set
02:17
remember to turn off the back light when
02:20
not required and save your battery power
02:22
to display the temperature pressure mode
02:25
button once and it’ll change between
02:26
centigrade and Fahrenheit press again
02:29
and you will get the humidity display
02:32
for where it is sensing press it once
02:36
more to return to the clock mode if you
02:40
press and hold for 2 to 3 seconds you
02:42
will get your firing mode which will
02:45
record your shots if you press your
02:48
backlight display button it will show
02:51
the results for up to the last 50 shots
02:54
press your mode button again to return
02:57
to your fire recording series if you
03:01
press the mode button again it will
03:04
display your rate of fire
03:09
make sure you have a safe backstop
03:11
before you start shooting if you fire
03:14
too close to the chrono you will get an
03:17
incorrect reading when you find the
03:21
recommended distance is 6 inches 150
03:24
millimeters away from the front of the
03:27
chrono for the sensors to make up fully
03:29
only shoot through the center of the
03:32
sensor square otherwise you will not go
03:34
to reading if you have excessive kick on
03:36
the gun please be advised if you may
03:40
damage the chrono when you have finished
03:43
your group of shots press the backlight
03:45
button to display the results of your
03:48
grouping if an error code is displayed a
03:52
means you’re not in recording mode II 1
03:55
and E 2 mean the front or rear sensor
03:57
has not picked up the shot
04:02
download your software from the address
04:04
shown and watch out for part of this
04:07
video installation of the software
04:20
[Music]
04:40
[Music]